home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.dcom.modems
- Path: news2.mv.net!usenet
- From: Marshall Richards <mcr@smile.mv.com>
- Subject: Win95 modem unistall/install problem
- Message-ID: <31483210.211D@smile.mv.com>
- Mime-Version: 1.0
- X-Mailer: Mozilla 2.0 (Win16; I)
- Content-Type: text/plain; charset=us-ascii
- Organization: MV Communications, Inc.
- Date: Thu, 14 Mar 1996 14:49:52 GMT
- X-Nntp-Posting-Host: smile.mv.com
- Content-Transfer-Encoding: 7bit
-
- I removed a Digicom softmodem and installed a new 288 modem, but get some
- strange blue warning screens on bootup and connect.
- Perhaps some of you have gone thru this and can make some suggestions.
- I first removed the Digicom with the modem icon in control panel or
- whatever.
- Then removed the Digicom card and installed the new modem. Rem,d the
- softmodem lines in autoexec. bat, booted up and got a blue screen with
- this warning:
-
- "16550 UART Emulator Disabled
- [Soft Modem] 16550 UART emulator is disabled because the data port on the
- DSI card was not found. You may experience problems running data, fax,
- and voice applications. This problem may be due to a hardware conflict
- and/or incorrect configuration settings. Please reconfigure hardware."
-
- After pressing any key to continue another blue screen comes up with:
-
- "For Your Information
-
- No Softmodem installed"
-
- Then I go on to dial up ISP and another blue screen comes up with:
-
- "DSP Board was not found on COM 4.
- Verify WIN.INI settings
-
- After all these warnings the modem goes on to connect and run
- properly......I think.
-
- Any suggestions will be greatly appreciated.
-
- Thanks,
- Marshall
-
-
-